heavy duty floor varnish
satin and dead flat finishes

satin

dead flat

  • heavy duty floor varnish    100ml
  • heavy duty floor varnish  1 litre dead flat
  • heavy duty floor varnish  1 litre satin
  • heavy duty floor varnish  4 litre satin
  • heavy duty floor varnish 100ml
  • heavy duty floor varnish 4 litre dead flat
zoom  click for a larger image

play

how-to video

ultra tough crystal clear protection for interior floors

An ultra hard, high quality coating with a satin or dead flat finish that dries to a crystal clear film with extremely good sanding properties allowing a very high quality of finish to be obtained. Formulated for floors and areas of high wear.


cures in 16 hours

find a stockist buy online abroad buy online UK
SKU : VHD100
Price range : £4.59 to £79.26
£4.59
+VAT
 
 
size

 
finish

 
quantity

 
go to basket

options
zoom click for a larger image (Any colours shown are representations and should be used as guidance only. Colours when applied will vary according to the material they are used on.)
  • dead flatdead flat
  • satinsatin

at a glance product info

  • interior - suitable for interior use interior
  • water resistant - resists water ingress making the water repellent surface highly durable water resistant
  • stain resistant - protects against discolouration, dirt and grease stain resistant
  • abrasion resistant - resistant to wear, scuffing and rubbing abrasion resistant
  • heat resistant - can accept hot cups and plates and is suitable for restaurant tables and bar tops heat resistant
  • chemical resistant - resistant to mild chemicals, alcohol, cleaning fluids, vegetable and fruit juice chemical resistant
  • ultra hard ultra hard
  • quick drying - for areas of high traffic where a fast dry and recoat time are essential quick drying
  • water wash up - containers and tools wash in water water wash up
  • 16 hour cure - fully cured the next day enabling full use of the surface 16 hour cure
  • food and child safe - when dry food and child safe

wooden floors • cork tiles • stone • slate • brick • quarry tiles • wooden worktops


available in: 100ml • 1 litre • 2 litre • 4 litre



drying time: 30-60 minutes • recoat time: 1-2 hours • curing time: 16 hours in ideal conditions. Allow 48 hours before heavy use. • coverage: 10-20 square metres per litre



application and advice

preparation


Thoroughly sand in the direction of the grain to remove all traces of old finishes and dirt, oil and contamination. Old floors can be impregnated with wax and grease - this will cause failure and must be completely removed. On new wood or if the old finish is in good condition, lightly sand to provide a key. Thoroughly clean after sanding.

application


Ensure the product is well mixed. Apply 3 coats of varnish. On new wood and porous surfaces dilute the first coat 10% with water. Lightly sand wood in between applications to remove any raising of the grain that may have occurred.
When using dead flat finish, if a very high level of durability and stain resistance is required, apply one or two coats of Heavy Duty Floor Varnish Satin Finish followed by one or two coats of Heavy Duty Floor Varnish Dead Flat Finish.

caution


Always apply to a test area before starting work. Appearance may vary according to the colour and type of wood and the number of coats.
Do not apply over uncured oil paints.

storage


Protect from extremes of temperature during storage and application. Do not use below 5 degrees C.

health, safety and the environment


Non-hazardous. Ensure good ventilation.
Keep out of reach of children.
Contact with eyes - wash immediately with warm water.
Remove excess from tools and mixing vessels before washing in warm soapy water.
Do not empty into drains or watercourses.



ask our expert