shopping basket0 item(s) - £0.00
UV blocking and absorption reduce greying, aging and deterioration of surfaces. Biocides protect against mildew, mould and fungus.
• wood • marine • worktops • doors • furniture • concrete paving • unglazed tiles • slate • brick
• dries very fast • cures in 16 hours • high water resistance • industrial level of finish • high resistance to chemicals alcohol and stains
at a glance product info
UV filter protection
water wash up
16 hour cure
does not blister or peel
food and child safe
application and advice
Remove all traces of old finishes, dirt, oil, wax and grease. These may have impregnated the surface and can cause failure. Sand in direction of the grain to provide a key. Thoroughly clean after sanding. Instructions in the technical data sheet must be followed. Ensure the product is well mixed but do not shake.
Apply 2 to 3 coats of varnish, with a good quality brush. On new softwood and porous surfaces dilute the first coat 10% with water. Lightly sand wood in between applications to remove any raising of the grain.
For a dead flat finish with high durability and stain resistance, apply two coats of satin followed by one of dead flat.
Always apply to a test area before starting work. Appearance may vary according to the colour and type of wood and the number of coats. Do not apply over uncured oil paints.
Protect from extremes of temperature during storage and application.
health, safety and the environment
Non-hazardous. Ensure good ventilation.
Keep out of reach of children.
Contact with eyes - wash immediately with warm water.
Remove excess from tools and mixing vessels before washing in warm soapy water.
Do not empty excess into drains or watercourses.