floor varnish
  • floor varnish
heavy duty satin and hardwearing dead flat finish
ultra tough crystal clear protection for interior floors

product

  • floor varnish
  • floor varnish 1 litre
  • floor varnish 4 litre
zoom  click for a larger image
floor varnish
heavy duty satin and hardwearing dead flat finish
ultra tough crystal clear protection for interior floors
This is the hardest of all 'one pack' varnishes. An ultra hard, high quality coating with a satin or dead flat finish that dries to a crystal clear film with extremely good sanding properties allowing a very high quality of finish to be obtained. Formulatated for floors and areas of high wear.
When using dead flat finish, if a very high level of durability and stain resistance is required, apply one or two coats of Floor Varnish Satin Finish followed by one or two coats of Floor Varnish Dead Flat Finish.

ideal for
• wooden floors • cork tiles • stone • slate • brick • quarry tiles • wooden worktops

unique qualities
• dries fast cures fast   highly heat and water resistant • ultra hard • clear as glass • good resistance to alcohol, stains and chemicals • resistant to heel marks • sands to a high-grade finish • easy to apply
• wash brushes in water




colours and options

floor varnish
heavy duty satin and hardwearing dead flat finish
zoom click for a larger image
  • dead flatdead flat
  • satinsatin

Any colours shown are representations and should be used as guidance only.
Colours when applied will vary according to the material they are used on.

 
find a stockist shop online

application

floor varnish
heavy duty satin and hardwearing dead flat finish

preparation
Thoroughly sand in the direction of the grain to remove all traces of old finishes and dirt, oil and contamination. Old floors can be impregnated with wax and grease - this will cause failure and must be completely removed. On new wood or if the old finish is in good condition, lightly sand to provide a key. Thoroughly clean after sanding.

application
Ensure the product is well mixed. Apply 3 coats of varnish. On new wood and porous surfaces dilute the first coat 50% with water. Lightly sand wood in between applications to remove any raising of the grain that may have occurred.

caution
Always apply to a test area before starting work. Appearance may vary according to the colour and type of wood and the number of coats.
Do not apply over uncured oil paints.

drying time: 30-60 minutes
recoat time: 1-2 hours
curing time: 16 hours in ideal conditions. Allow 48 hours before heavy use.
coverage: 10-20 square metres per litre
available in: 1 litre • 2 litre • 4 litre

shop online

storage and safety

floor varnish
heavy duty satin and hardwearing dead flat finish

storage
Protect from extremes of temperature during storage and application. Do not use below 5 degrees C.

health, safety and the environment
Non-hazardous. Ensure good ventilation.
Keep out of reach of children.
Contact with eyes - wash immediately with warm water.
Remove excess from tools and mixing vessels before washing in warm soapy water.
Do not empty into drains or watercourses.

 
find a stockist shop online

video

 
find a stockist shop online

datasheet

floor varnish
heavy duty satin and hardwearing dead flat finish

Download the datasheet here





  • floor varnish
  • floor varnish 1 litre
  • floor varnish 4 litre
zoom  click for a larger image

location chooser

United Kingdom

EU

USA and Canada

Rest of the World

translate

English Basque Bulgarian Catalan Croatian Czech Danish Dutch Estonian Finnish French German Greek Hungarian Irish Italian Maltese Norwegian Polish Portuguese Romanian Slovak Slovenian Spanish Swedish Thai Welsh

which Polyvine varnish?

Click here to see our handy chart that helps you choose which of the Polyvine varnish range is suitable for your application.

 

which-varnish-thumb