• textiles • rubber • plastic laminate • wood • plywood • chipboard • painted surfaces • plaster • metals (prime with Polyvine primer) • cork • leather • canvas • expanded polystyrene
• non-flammable • fume free • high strength • water resistant • much better coverage than solvent systems
Surfaces to be bonded must be clean, dry and free from grease and oil. Smooth or polished surfaces should first be roughened with fine abrasive. Rubber and similar material must be abraded well and then the bonding area vigorously wiped with a spirit based cleaner. A priming coat will be necessary on absorbent surfaces.
Apply a smooth thin layer of adhesive to both surfaces by brush, roller, pad or spray. Allow to dry 10-15 minutes. The white adhesive becomes clear when ready to bond. Bring the two surfaces into contact within 4 hours of application. Apply as much pressure as possible over the entire bond area. Clean spreaders in water. Remove surplus with a damp cloth whilst wet.
storage and safety
Protect from extremes of temperature during storage and application.
health, safety and the environment
Contact with eyes or skin - wash immediately with water.
Do not empty into drains or watercourses.
Download the datasheet here