To provide extended durability to the timber, precoat with one of the Polyvine Woodstain Oils.
• decking • timber cladding • fencing • garden furniture
• solvent free • water repellent • does not blister or peel • very high solids • UV protective filters • microporous • biocides protect against algae, mildew and fungal attack
New timber should be clean, non-oily and thoroughly dry. Remove all old coatings to bare wood. If the timber is not pressure treated apply an appropriate wood preservative. Instructions in the technical data sheet must be followed. Stir thoroughly.
Apply a thin even coat, work the oil into the grain of the wood. Brush out well. When dry (minimum 12 hours), apply a second coat. Use a good quality brush. Do not apply below 5° C.
Always apply to a test area before starting work. Do not apply when rain is imminent. Timbers containing high natural oils, e.g. Teak and Iroko, may inhibit drying and cause impaired adhesion. Wiping surface with methylated spirit will assist adhesion. Application rollers, sponges and pads, or clothes soaked in this product, may spontaneously combust if left. Dispose of after soaking in water.
Wear a suitable face mask if dry sanding.
storage and safety
Protect from extremes of temperature during storage and application.
health, safety and the environment
Keep out the reach of children. If swallowed, seek medical advice immediately and show this container or label. Use only in well ventilated areas.
Do not empty into drains, dispose of this material and its container at hazardous or special waste collection point.
Download the datasheet here