Available in satin and dead flat. 3 coats of satin must be applied before the dead flat finish to achieve full protection.
• exterior doors • windows • woodwork • garden furniture
• UV protective filters • waterproof • quick drying • microporous • resists blistering and cracking • high solids • biocides protect against algae, mildew and fungal attack
colours and options
All surfaces must be clean and free from dust, dirt, oil and contamination. Remove oils/resins from oily hardwoods and resinous softwoods. Treat new wood with a wood preservative to remove all traces of fungus and mould. Ensure pretreatment is compatible and completely dry, before application. Joints, end grain and glazing beads must be completely sealed. Water penetration into the timber will produce unsightly water staining and promote fungal growth beneath the clear varnish.
Instructions in the technical data sheet must be followed. Ensure the product is well mixed. Using a good quality brush, apply evenly using light brush strokes, following the grain of the wood. Keep a wet edge and avoid overlaps. Apply the first coat and allow to dry. On new wood dilute the first coat with 10% water.
Sand lightly to obtain the best finish. Apply three coats.
Always apply to a test area before starting work. Care must be taken when applying in high temperature or direct sunlight as this will affect drying time.
Do not apply when rain is imminent. Coating life will be reduced on horizontal surfaces and where the coating is in contact with the ground or pooled water.
storage and safety
Protect from extremes of temperature during storage and application.
health, safety and the environment
Keep out of reach of children. Non-hazardous. Ensure good ventilation.
Contact with eyes - wash immediately with warm water. Remove excess from tools and mixing vessels before washing in warm soapy water.
Do not empty into drains or watercourses.
Download the datasheet here