hickson decor wood stain
translucent satin finish
  • wood stain 1 litre
zoom  click for a larger image
stains and protects wood
Specially formulated to provide practical advantages over alternative types of exterior finishes such as traditional paint, varnish or polyurethane, it is a complete finish in a single can, eliminating, if desired, the need for a separate primer or undercoat and providing low maintenance, long-term protection.
The translucent semi-gloss finish enhances and protects the natural appearance of wood.

ideal for
• window frames • doors • cladding • fascias • all internal and external woodwork

unique qualities
• highly UV resistant • long lasting protection • water repellant • allows wood to breathe • resists flaking and peeling

options
zoom click for a larger image (Any colours shown are representations and should be used as guidance only. Colours when applied will vary according to the material they are used on.)
  • ebonyebony  
  • light oaklight oak  
  • mahoganymahogany  
  • natural looknatural look  
  • pinepine  
  • pitch pinepitch pine  
  • red cedarred cedar  
  • redwoodredwood  
  • teakteak  
  • walnutwalnut  

find a stockist shop online

at a glance product info

  • exterior
    exterior
  • water resistant
    water resistant
  • UV filter protection
    UV filter protection
  • microporous
    microporous
  • biocide boost
    biocide boost
  • high particle content
    high particle content
  • does not blister or peel
    does not blister or peel

available in: 500ml • 1 litre • 2.5 litre


drying time: Touch dry 3-5 hours • recoat time: Allow 24 hours between coats • coverage: 11-18 square metres per litre, depending on substrate

application and advice

preparation
New timber should be well sanded, non-oily and thoroughly dry. Old paint, stain or varnish - strip back to bare wood, sand and clean, coat as new wood.

application
Stir thoroughly before and during use. Do not apply below 5°C. Brush apply evenly with the grain in a full flowing coat, do not overbrush. Apply three coats, allowing 24 hours between each.
Recoating will be required every 3-8 years depending on degree of exposure. Clean down and lightly sand.

caution
Timbers containing high natural oils, e.g. Teak and Iroko, may inhibit drying and cause impaired adhesion. Wiping surface with methylated spirit will assist adhesion.
Application rollers, sponges and pads, or clothes soaked in this product, may spontaneously combust if left. Dispose of after soaking in water. Wear a suitable face mask if dry sanding.

storage
Protect from extremes of temperature during storage and application.

health, safety and the environment
Clean brushes and spillages with white spirit.
May produce an allergic reaction. Flammable. Toxic to Aquatic organisms, may cause long-term adverse effects in the aquatic environment. Repeated exposure may cause skin dryness or cracking. Vapours may cause drowsiness and dizziness. Keep out of the reach of children. If swallowed, seek medical advice immediately and show this container or label. Use only in well ventilated areas. Do not empty into drains, dispose of this material and its container at hazardous or special waste collection point. Restrict interior use to small surface areas such as doors, skirting boards and window frames. Not recommended for interior use on large surface areas. During spraying, wear suitable respiratory protective equipment. After contact with skin, wash immediately with plenty of soap and water or a proprietary skin cleanser, do not use solvent, thinners or white spirit.



ask our expert

view or download a datasheet

hickson decor wood stain
translucent satin finish

find the right product for the job - adhesives woodstain oil wood varnish woodoil hickson decor antislip hickson decor waxcoat hickson decor woodstain woodstain woodstain oil wood varnish woodoil hickson decor antislip hickson decor waxcoat hickson decor woodstain woodstain